1.Press SNOOZE/DIMMER button to silence the alarm sound temporarily for about 9 minutes, the
alarm will active again after 9 minutes lapse. The snooze function is repeatable for 60 minutes.
2.To switch the alarm sound off, you can press or button.
5.Press again and press or to select one of BUZZ, FM RADIO or
iPod/iPhone/iPad as the wake-up alarm, when the alarm mode icon will appear on the display.
●
When the alarm is set to FM radio, the radio frequency last used will be used as the alarm radio
frequency.
●
If in case the iPod/iPhone/iPad wake-up mode is selected and no iPod/iPhone/iPad was plugged
in, the BUZZ will sound instead.
6.At any stage above, if no key is pressed for about 5 seconds, the last selected value is automatically
saved and exit.
7.The setup of ALARM2 is the same with ALARM1.
Tips:The alarm volume will increase gradually.
●
iPod touch (4th generation)
●
iPod touch (3rd generation)
●
iPod touch (2nd generation)
●
iPod touch (1st generation)
●
iPod nano(6th generation)
●
iPod nano (5th generation)
●
iPhone 4
●
iPhone 3GS
●
iPhone 3G
●
iPhone
●
iPad
●
iPad 2
In playback mode, press VOL+ and VOL- to adjust the volume. The volume level range from 00 to
32.
Adjusting the Volume
1.In standby mode, press and hold the TIME SET button until “12H” flashes. Press or to
set “12H”(12 hour format) or “24H”(24 hour format).
2.Press TIME SET, and “hour” flashes.Press or to set the hour.
3.Press TIME SET again, and “minute” flashes.Press or to set the minute.
At last press TIME SET to confirm.
4.At any stage above, if no key is pressed for about 5 seconds, the last selected value is automatically
saved and exit.
Setting Clock Manually
Snooze Function
Sleep Function
This function switches the unit from playback mode to standby mode after the specified time.
1.Press the SLEEP button repeatedly to select the sleep time. The cycle goes “OFF” means no
sleep function.
2.After the sleep mode is activated, the SLEEP icon will appear on the display. And press the
SLEEP button to display the remaining time before switching to standby mode.
Dimmer Function
Three levels of brightness are available by pressing SNOOZE/DIMMER.
High(default)
→
Middle
→
Low
Middle
90
→
60
→
30
→
15
→
10
→
5
OFF
1.The unit has two sets of alarm, (ALARM1) and (ALARM2).
2.In standby mode, press button and icon will appear on the display. ALARM1 is
activated. Press again to cancel and icon disappears.
3.In standby mode, press and hold until “hour” flashes. Press or to
set the hour.
4.Press again, and “minute” flashes.Press or to set the minute.
Setting Alarm
When the first time using this unit or after a power interruption, you can synchronize the time with
iPod/iPhone/iPad. Plug your iPod/iPhone/iPad, switch to playback mode, and select iPod/iPhone/iPad
mode. The time on the display ”12:00” is flashing. Press and hold the MENU button until the display
shows “SYC”. Then the same time with iPod/iPhone/iPad will show on the display.
Time Synchronization
Tips: Not all the models of iPod/iPhone/iPad support time synchronization function.
The supported models include: