Press the MODE button again,logging out the memory mode,return to the
state that all of the 6 lower cursors displaying,and carry on the second set.If
no longer set,press the MODE button again,exit the MEMORY state,and
enter the next operation mode.
COINS-
the detector eliminates the iron,pull-tabs and S-CAP,only be respond
to all kinds of coins.
● SENS Button:choose the 4 levels with SENS button.Boot setting is at the
middle value(the second gear).The highest sensitivity is the fourth
level.When there is interference,setting the sensitivity lower properly.In the
PINPOINT mode,the SENS button is useless.
● PP Button:touch the “PP”button,the detector turns into PINPOINT
mode,and it no longer has the ability to identify.At this moment,the PP cursor
is lighted,and indicates the signal strength.The more close to the metal
target,the more the strength cursor is lighted,the more louder the sound is,in
order to locate the target position accurately.Touch the “PP”button again,exit
the PINPOINT state.
QUICK START
1. Prepare with the four metal samples
● an iron nail
● a 5
￠
dollar nickel coin
● a 1
￠
dollar zinc coin
● a 25
￠
dollar silver coin
2. Lay the detector
Place the detector on a wooden or plastic table,let the search coil exceeds
the table edge about more than 30cm.Keep the detector be away from the
wall,ceiling and floor,turn off all the equipment which can cause
electro-magnetic interference.Please take off the watch,ring or other metal
objects on your hand.( See Fig.8).
Fig.8
Summary of Contents for PHMD74
Page 1: ...PHMD74 USER MANUAL...
