www.PyleUSA.com
4
www.PyleUSA.com
5
1
2
3
4
6
5
7
8
BODYPACK TRANSMITTER
1. Antenna
2. Volume Adjust and ON/OFF button
3. Microphone Connector
4. CH Button DOWN
5. CH Button UP
6. LED Display
7. Battery compartment
Double AA batteries (AA 1.5VX2)
8. Headset microphone
(Lavalier microphone)
OPERATION
Tips:
Under normal circumstances, the product has been completed at the factory, and
can be used normally after opening the box, no need to adjust the frequency.
If you need to adjust the frequency, please follow the steps below.
Note:
Before operating, make sure the transmitter and receiver are both off.
The operation sequence of handheld microphone:
1. Operate the transmitter
2. Open the receivers
3. Confirm at the transmitter
1. Press and hold the power button and CH button of the transmitter at the same
time until the LED display flashes then release the button.
2. Turn ON the receiver power button, please pay attention to the RF signal indicator
of receiver. Under normal circumstances, the receiver RF signal indicator flashes
continuously for 4 times and then goes out. (In this case, the receiver and the
transmitter are connected successfully.)
3. Short press the transmitter CH button to confirm the connection between the
transmitter and the receiver. At this time, the transmitter display stops flashing,
and the receiver RF signal indicator is always ON, indicating that the receiver and
the transmitter are connected successfully.
Note:
If it can’t be connected, please repeat the above operation.
(The transmitter must be operated before the receiver is turned ON.)
When the same frequency interference occurs, please short press the transmitter
CH button. At this time, the transmitter will change the frequency to avoid
frequency interference.
Bodypack Transmitter Operation Sequence
1. The transmitter and receiver are both off.
2. Press and hold " " CH button and turn ON the power switch button to "
ON
" at
the same time until the LED display flashes for 4 seconds, then release the " "
CH button.
3. Turn ON the receiver power button, pay attention to the RF signal indicator of
receiver. Under normal circumstances, the receiver RF signal indicator flashes
continuously for 4 times and then goes out.
(ln this case, the receiver and the transmitter are connected successfully)
4. Short press the transmitter " " CH button to confirm the connection between
the transmitter and the receiver. At this time, the transmitter display stops
flashing, and the receiver RF signal indicator is always ON, indicating that the
receiver and the transmitter are connected successfully.