INSTALLING THE BATTERY
The Watch uses 1 piece CR 2032 batteries. Use only the recommended
batteries.
NOTE
: Changing the battery will erase the data in the watch previously
input into the device and you can then/will need to re-set the watch all
over again.
1.
The battery compartment is located at the back of the unit
2.
To install/replace the battery, unscrew the battery compartment
with the screw driver and simply slide afterwards
3.
Take out the old battery and dispose of properly
4.
Gently place a new battery into the battery slot of the battery
compartment, make sure that the poles are correctly placed
Screw back the battery compartment, when finished as in the diagram
below
IMPORTANT BATTERY INFORMATION
Battery installation and removed should be performed by an
adult
Use only batteries recommended in this instruction sheet
Be sure to install the batteries with the correct polarity, as
indicated
Remove all batteries when replacing the old batteries with new
batteries
Only batteries of the same and equivalent type as
recommended are to be used
Do not short-circuit the supply terminals
