Precautions
If there is smoke or any peculiar odor present during used
Please read this user guide completely and carefully prior to attempt to install your new car
video equipment. Install correctly, your new equipment will provide you with years of enjoyable
and safe usage.
Installing this unit requires technical expertise. This unit should be installed by a qualified
technician or service personnel. If you try to install this unit by yourself, do it properly, referring
to the installation and wiring diagrams in this operating manual. Improper installation may
result in fire or electric shock.
1.Do not operate this equipment while driving-safe driving should always be your highest priority.
2.Do not install components in areas which are susceptible to rain, moisture direct sunlight,
extremely heat or cold, excessive dust, dirt or humidity.
3. Immediately unplug the power cord and send the monitor to your local dealer or service
center as soon as possible:
a)
b) If there is damage to any of the internal components
4. To avoid damage to the unit and risk of electronic shock, do not permit any of this equipment
to become damp or wet from water or liquid. If this does occur, immediately unplug the power
cord and send the unit to your local dealer or service center as soon as possible.
5. Do not attempt to repair, open or disassemble any of the components. Dangerous high
voltages are present which may result in electric shock.
6. Use only a power source with DC12~24 volts car battery (negative ground).
7. Do not place or suspend objects on the power cord, as this may damage the cord.
8. Do not twist or place the power cord near any source of heat in the vehicle.
9. Do not attempt to repair a damaged, broken or faulty power cord. Replace it with a new one
immediately.
10. Avoid dropping any metal objects or inflammable items into the unit ventilation slots.
11. After the unit is installed, do not arbitrarily pull it down or strike it. This may loose the
mounting screws and cause it fall down.
12. Do not install your monitor where:
a) it will obstruct the driver ’s view.
b) it will obstruct the operation of the air-bag system.
c) it will obstruct the operation of the vehicle, especially the steering wheel, shift lever, or
brake pedal.
d) a diver or passengers may injure themselves when getting into or out of the car.
13. Do not damage any pipes, tubes, the fuel tank or electric wiring when installing this unit.
this can cause a fire. if you drill a hole in car panels, make sure that any hidden car parts will
not be damaged.
14. do not use any nuts or bolts for safety devices such as steering linkage, fuel supply or
braking systems. this can cause a fire or an accident .take care to prevent cords and wires
from getting tangled or crimped in the moving portion of a seat rail.
3
1. Introduction
