5
PLAY A RECORD
1. Raise the dustcover
2. Connect the AC power cord to an electrical outlet(120V-60Hz)
3. Place a record on the turntable and set the player speed to match the record speed
(33/45/78).
NOTE: when playing a single (a 45 rpm record) and/or records with large centre holes,
use the 45 rpm adapter.
3. Remove the tone arm from the rest, push lift lever backward to raise the tone arm and
gently move the tone arm to the desired position over the record. The turntable will
begin to spin when the tone arm slowly onto the desired position on the record to
begin playing the record.
4. Turn the manual stop control to right, the turntable platter will stop at once, turn it to
left the turntable platter will start again.
5. If the Auto Stop Control is turned ON, record will stop automatically when finished.
If the Auto Stop Control is turned OFF, record will NOT stop automatically when the
finished .
6. For best performance and product maintenance, unplug the turntable when not in use.
HOW TO REPLACE THE STYLUS (NEEDLE)
To replace the turntable stylus(needle), please refer on the instructions below.
Removing the TURNTABLE STYLUS (needle) from the cartridge
1. Place a screwdriver at the stylus tip and push downward as shown in diagram “A”.
2. Remove the stylus by pulling the stylus forward and pushing downward.
Inserting the stylus(needle)
1.Hold the tip of the stylus and insert the
stylus forward and pushing downward.
2.Push the stylus upward and direction “C”
until the stylus locks into the tip position
