Attach the two antennas and extend them vertically. Switch
on the receiver. The red power indicator will come on.
on to
indicate signal reception. The green AF LEVEL meters
indicate the audio level.
Switch on the transmitter. The red indicator RF/Channel1,
RF/Channel2, RF/Channel3, RF/Channel4 will come
VOLUME
CHANNEL 1
RF
AF LEVEL
POWER
CHANNEL 2
RF
AF LEVEL
CHANNEL 3
RF
AF LEVEL
CHANNEL 4
RF
AF LEVEL
VOLUME
VOLUME
VOLUME
1. Power Indicator
2. Power Switch
3. Antenna
4. CH-1 RF Signal Indicator
5. CH-1 AF Indicator
6. CH-2 RF Signal Indicator
1
2
3
3
4
5
6
7
8
9
10
11
12
13
14
15
16
16
7. CH-2 AF Indicator
8. CH-3 RF Signal Indicator
9. CH-3 AF Indicator
10. CH-4 RF Signal Indicator
11. CH-4 AF Indicator
12. CH-1 Volume Control
13. CH-2 Volume Control
14. CH-3 Volume Control
15. CH-4 Volume Control
16.
Rack Mounts
FRONT PANEL
PDWM4400 VHF PROFESSIONAL FOUR CHANNEL WIRELESS MICROPHONE SYSTEM
Adjust the volume of receiver, transmitters and amplifier.
Please switch off the receiver, transmitters and amplifier
when the wireless microphone system is not being used.
17.Mixed balanced output jack
18.Mixed unbalanced output jack
19.Individual unbalanced output jack
20.Squelch adjustor
21.DC Power in
Note that switching the microphone on and off can cause interference
that will be heard if the microphone volume level of the amplifier
system is still set high.
SQUELCH
The squelch control on the rear of the receiver is preset at the factory.
If you must use the system in an area with considerable RF
interference and there is some noise from the receiver when your
transmitter is off, you can adjust the squelch control so that the system
will receive the signal from your transmitter only but squelch or
eliminate the unwanted background RF noise. This adjustment can
17
18
19
20
21
REAR PANEL
cause reduction in useable range of the wireless transmitter, so set the
control to the lowest position that reliablely mutes the unwanted RF
signals.
XLR MIXED
MIXED
