www.PyleUSA.com
6
USING THE BODY-PACK TRANSMITTER
1. Open the transmitter battery compartment and insert a fresh 9V battery. Observe
proper battery polarity ( “ +/–” ).
2. Turn
ON
the microphone power switch and the power indicator will be lit.
The transmitter will send the signal to the receiver and the RF indicator is lit.
3. Turn
OFF
the transmitter when not in use.
4. When the low voltage indicator is lit, it means the battery is not enough. If it does
not operate normally (The distance between the receiver and transmitter is not
far enough or the voice is distorted) install fresh battery.
5. Remove the batteries when the unit will not be used for a long time.
TROUBLESHOOTING
BREAK DOWN REASONS SOLUTION
The power indicator
is not
ON
1. The transmitter does
not load the battery,
low battery or wrong
battery polarity.
2. The power jack of the
receiver is not attached
3. Power switch is
OFF
1. Install fresh battery.
2. Connect the
receiver’s power.
3. Turn
ON
receiver’s
power.
No voice
1. The transmitter is not
turned
ON
.
2. The AF cord of the
receiver has not been
connected.
3. The volume of the
receiver or the loud
speaker is too low.
4. The transmitter is far
from the receiver.
1. Turn
ON
the
transmitter
2. Connect the receiver
and loudspeaker.
3. Turn up the volume
4. Do not place the
transmitter far from
the receiver.
