BALANCE CONTROL
1). Press the SEL button to select the balance mode until BAL appears on the display.
2). Press the + button or - button to increase or decrease the sound level of
2). Press the + button or - button to increase or decrease the sound level of
left or right speaker.
front or rear speaker.
4. LCD ( LIQUID CRYSTAL DISPLAY)
3. BAND BUTTON
Press it to select your desired radio band and word which band is selected
will be displayed on LCD.
FADER CONTROL
1). Press the SEL button to select the fader mode until FAD appears on the display.
TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
No power
Disc cannot
be loaded or
ejected
Cause
The fuse is blown
Presence of CD disc inside
the player
Inserting the disc in upside
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum
No sound
The operation
keys do not
work
Sound skips
The antenna cable is not
connected
the signals are too weak
Insert the antenna cable firmly
select a station manually
The radio does
not work
the radio
station
automatic
selection does
not work
The built-in microcomputer
is not operating properly
due to noise
Press the RESET button
front panel is not properly
fix into its place
Wiring is not properly
connected
The installation angle
is more than 30 degrees
The disc is extremely
dirty or defective
Clean the compact disc/try to
play a new one
Adjust the installation angle
to less than 30 degrees
Adjust volume to a desired level
Check wiring connection
Leave the player off for an
hour or so, then try again
Cool off until the ambient
temperature returns to normal
Clean the disc or try to play a
new one
Insert the compact disc with
the label facing upward
Remove the disc in the player
then put a new upward
Replace the fuse
The car ignition is not on.
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
Solution
6. EJECT BUTTON
Press it to eject the disc from the slot.
7
4
2. OPEN BUTTON
Press it to eject the front panel when you want to take away.
7. DSP( DISPLAY) BUTTON
8. MUTE BUTTON
Press this button to eliminate the sound temporarily, press it again to
resume normal play state.
5. CD ( CD PLAY, PAUSE) BUTTON
At tuner mode, press button to switch to CD mode. At CD mode,
press it to pause the CD program and press it again to resume CD
playback.
Press it to apply those functions, press it continually to switch between 4
preset equalizer curves: FLAT, POP, CLAS, ROCK. The sound quality will
be changed. Press it again to resume initial default mode.
