PYLE HEALTH PHLIRG39, User Manual

Page: 6 / 8

6
water switch located on the handle of irrigator (fig.6) by sliding it up. Keep your mouth
slightly poer to allow the water to run into the washbasin. You can block jet anytime sliding
down water switch on the handle.
Direct the jet stream along the gum line with the jet tip. It can flush away the food particles
remains on the teeth or between the teeth effectively and massage the gum gently.
After Use
According to studies of periodontal disease cases, the early stages of plaque formation
are often ignored because of the lack of clear symptoms. Typically the disease is allowed to
progress until the more serious middle or last stages. Bleeding from the gums upon use of
the irrigator is symptomatic of periodontal disease, however, continued use of the irrigator
tends to alleviate these symptoms and allows the gums return to a healthier state. If the
bleeding carries on for more than two weeks, please consult your dentist.
After use, always empty the water tank, spray tube and nozzle entirely to prevent creating
any bacteria from the standing water. Turn the power on button off. Take off the nozzle and
store it into the nozzle retaining box. Wipe the handle dry and place it back onto its base.
Clean and Maintenance
Before cleaning and maintaining the irrigator, always unplug from the electrical outlet first.
Regularly clean the housing with a damp cloth. The Water Tank and Nozzle are removable
and dishwasher-safe. When cleaning, please do not use and rough tool or utensil to wash
the main body (such as scrubbing pad) to prevent the irrigator from damaging.
Check and Installation
Every unit packed with 4 nozzles and a screw bag. After unpacking, please check them
first. If there is any parts missing or broken, please contact your local dealer for replacement.
The spray tube, nozzles or water tank may be with several drops of water left inside. It is left
from the test. It is distilled water that is safe and hygienic. It is no harm to the health.
Do not repair or modify this irrigator yourself. If parts need to be replaced, changed or
repaired, please contact your local dealer or an authorized service center.
Wall Mounting Installation
Take off the rear panel by pushing it downward. Drill two bores in the wall and drive two
plastic inserts into. Screw in the rear panel (fig.7) . take the power cord out of the storage box
and fit it through the hole of rear panel. Do not press too hard to damage the power cord
(fig.8) . please make sure to screw in tightly (fig.9) .