5
NOTE: The steamer does not require distilled water. Residents in areas with hard water
should used distilled water for better performance.
6) Twist the quick release cord wrap clockwise to un-wrap the power cord completely.
Hang the cord on the handle cord wrap for better use of the steamer when moving
and cleaning.
7) The LED will illuminate when the steamer is ready for cleaning (Aqua Laser only).
NOTE: It is recommended that another high wattage appliance is not operated on the
same circuit to avoid a circuit overload.
CAUTION: Upon initial use, please hold trigger to allow the water to flow
thru the system for approximately 30 seconds to prime the unit.
WARNING: ON SURFACES THAT HAVE BEEN TREATED WITH WAX, THE
WAX MAY BE REMOVED BY THE HEAT AND STEAM ACTION. DO NOT USE ON
UNSEALED WOOD FLOORS OR LET UNIT STAND ON ANY WOOD FLOOR FOR AN
EXTENDED PERIOD OF TIME. THIS MAY CAUSE THE WOOD GRAIN TO RISE. IT
IS RECOMMENDED THAT A SECTION BE TESTED IN AN ISOLATED AREA OF THE
FLOOR. IT IS ALSO RECOMMENDED THAT YOU CHECK THE USE AND CARE
INSTRUCTIONS FOR CLEANING FROM THE FLOOR MANUFACTURER TO ENSURE
STEAM CLEANING IS ACCEPTABLE FOR YOUR FLOOR.
8) Slowly pass over surface to be cleaned while pressing trigger to emit steam. It is
recommended to sweep or vacuum floor prior to using the steamer.
9) With steam control options, push button to choose a setting that best fits your
cleaning needs. Scrub for deep cleaning, mop for general day to day cleaning, or
dust for quick cleaning.
10) Use vibrate setting in order to provide additional cleaning power.
CAUTION: To sanitize an area of your floor, leave the steamer over the
area for a minimum of 8 seconds, but no longer than 15 seconds. Leaving the
steamer in a stationary position for a longer period than recommended may
cause build up of pail residue. This residue can be removed by using a
decalcifying product or with a few drops of vinegar.
PSTM40
Steam
control
DUST
MOP
SCRUB
Push
backward
to
remove
water
tank
Vibrate