4
OPERATING INSTRUCTIONS
POWER SOURCE
1. Connect the AC adaptor to the DC IN jack on the back of of the unit firmly, and plug
it into a wall outlet.
2. Slide the power switch on the back of the unit to
“ON” positon, the unit is in standby
mode, and
display shows “--:--” with flashing digits.
3. You can now press the
button on unit or remote control to turn on the unit. The
display shows “HELLO”. Press the
button on unit or remote control to turn off the
unit, then the
display shows “GOOD--BYE”.
4. Slide the power switch on the back of the unit to
“OFF” positon, and pull the AC
adaptor out of the wall outlet if you
want to switch off completely.
CLOCK SETTING
During in the STANDBY mode:
1. Press and hold
PROG.
button on unit or remote control until the time displays 24-
hour digit flashing.
2. Press
or
button to adjust 12-hour or 24-hour digit.
3. Press
PROG.
button again, the time display HOUR digit flashes, press the
or
button to adjust HOUR digit. Press
PROG.
button once more, the MINUTE digit
flashes, adjust it by the
or
button.
4. Press
PROG.
button again to confirm the time.
5. Each enable state as shown above will be cleared if the key is not pushed in 10
seconds.
RADIO OPERATION
TUNNING
1. Press
STANDBY/ON
button on the unit or remote control to turn on the unit and
press the
FUNCTION
button on the unit or
FM
button on remote control to select the
TUNER mode.
2. Press
or
button will change the frequency by 0.05MHz.
3. Press
or
button for approx. 1 second to active automatic tuning. Automatic
tuning stops when the first station with a sufficiently strong signal has been found.
The display shows STEREO when a stereo signal is beiing received.
MONO/ STEREO SELECT
This unit can receive the FM mode only. When you press
FM MONO/STOP
button on
remote control, the FM STEREO indicator will turn
off & switch to MONO FM status.
STATION MEMORY
You can also preset stations of your choice and store up 20 FM stations in its memory.
1. Tune to the required station.
2. Press
PROG.
button on unit or remote. The station
number flashes in the display.
3. Press
or
button for your desired station number.
4. Press
PROG.
button to store the station.
5. Repeat steps 1 to 4 to store more stations or change previously stored stations.
