PYD Electrobombas MP Series, Manual, Page: 9 / 21

www.proindecsa.com / proindecsa@proindecsa.com
INSTRUCTIONS MANUAL AND MAINTENANCE
SERIE MP
9
ENG
Before starting the pump:
- Make sure that the mains voltage and frequency are the same as on the rating plate.
- Make sure that the capacitor matches the pump motor requirements (for single-phase motors).
- Make sure that the pump is fully submerged (for submersible pumps).
- Check the direction of rotation.
- Never run the pump dry.
- Never change the position of the level switch set by the manufacturer.
It is recommended to install a pipe with a larger diameter than the pump drive to reduce friction
losses as much as possible.
Install a check valve at the pump outlet to prevent the pipe from draining every time the pump
stops. Avoid bends and turns in the piping and ensure a correct connection between the piping
and the pump drive. Both cases affect the correct operation and performance of the pump.
3. INSTALLATION INSTRUCTIONS
MODELO A B C D E Kg
MP80 177 382 165 175 150 8
MP100 200 405 165 175 150 9
MP120 223 428 165 175 150 10
FLOW
m
3
/h 0 0,6 1,2 1,8 2,4 3,0 3,6 4,2 4,8 5,4 6
l/min 0 10 20 30 40 50 60 70 80 90 100
MODEL
DN INT (A) POWER
CON
Ø” 220V
KW
(P
1
)
KW
(P
2
)
Hp
(P
2
)
µF LOADING HEIGHT IN METRES
MP80 1 3,7 0,8 0,55 0,75 16 33 32 30,5 28,5 26 23 19,5 15,5 11
MP100 1 4,3 1,1 0,75 1,00 20 44 42 40 37 34 30 25,5 20,5 15 9
MP120 1 7,0 1,2 0,90 1,20 20 55 52 49 46 42 38 33 27 20,5 13,5 5