Depending on a situation, the diode signals the following:
•
start of the lamp – quick flickering of the diode for 2 seconds
•
DMX signal receiving – slow flickering of the brightness adjustment
button (1Hz frequency) in the first minute after receiving the DMX
signal
•
after the start of the lamp in case of the loss of DMX signal – diode
lights (continuously) for 1 minute
•
if the state of DMX signal changed (if there wan no DMX signal and it
returned, or vice versa) – diode signals it for 1 minute
•
damage of the temperature sensor module – diode does not go out
after 1 minute
To change the brightness, press and hold down the control button. If
during the brightness adjustment the button diode starts flickering, it means
that the extreme value (minimum or maximum) has been reached.
It is possible to change the adjustment direction without reaching
extreme values. For example, while the lamp brightness is increased, release
the control button for a moment. The diode will signal the change of
adjustment direction. The pressing of the adjustment button again will cause
the dimming of the lamp (brightness decrease).
While the lamp operates, the diode stays switched off (excluding
situations mentioned above).
8