1
The PiXiMo 12350 driver is designed to control LEDs, it is ideal for use in simple systems. Built-in
receiver allows to control of 12 channels directly with DMX protocol. To each of the 12 channels
you can connect up to three Power LEDs.
The PX268 can only be controlled with DMX. Built-in DIP switch allows you to set the starting
address of the first channel. The rest of DMX channels are assigned the following after each other
higher addresses. The value of this address is set in binary code. In addition, the last section of
the switch allows you to activate the Smooth option. This feature smooths the transition between
successive control signal values for fluent changes of color in the connected lamps.
The driver is produced in DIN rail compatible casing - 6 standard DIN modules wide.
1. GENERAL DESCRIPTION
2. SAFETY CONDITIONS
PX268 LED Driver 12 x 350 mA is a device powered with safe voltage 12; however, during its
installation and use the following rules must be strictly observed:
1. The device may only be connected to 12V DC with current-carrying capacity compatible with
technical data.
2. All the conductors should be protected against mechanical and thermal damage.
3. In the event of damaging any conductor, it should be replaced with a conductor of the same
technical data.
4. Use only shielded cables to connect the DMX signal.
5. All repairs and connections of outputs or DMX signal can only be made with cut off power
supply.
6. PX268 should be strictly protected against contact with water and other liquids.
7. All sudden shocks, particularly dropping, should be avoided.
8. The device cannot be turned on in places with humidity exceeding 90%.
9. The device cannot be used in places with temperature lower than 2°C or higher than 40°C.
10. Clean with damp duster only.
