XTERNA Module
Issue 2 (01 October 2018)
www.pvelectronics.co.uk
- 14 -
4.12 Transmitter Module
Cut 17cm of the cable supplied, strip off 3mm of the insulation
from one end and tin the wires. Then attach to the end pad of the
Transmitter module as shown.
4.13 Final Assembly
Re-attach the GPS module, not forgetting the M3 X 4mm screw.
Orient the notch on the IC with the corresponding marking on the
socket and push into the socket. Push in the Transmitter module,
with the three pins in the three holes closest to IC1. Feed the
antenna wire around the battery holder. Finally screw the PCB to
the base of the case with the remaining three self-tapping screws.
