Nixie Clock Kit ' Maestro’
ISSUE 5 (01 June 2018)
www.pvelectronics.co.uk
- 6 -
2.
TOOLS AND EQUIPMENT REQUIRED
2.1
Tools required to assemble the PCB.
The following tools will be required to assemble the PCB:
-
Soldering iron with a small tip (1-2 mm).
-
Wire cutters to trim the excess component leads after soldering.
(Tip: A small pair of nail clippers works very well for this function).
-
Wire strippers (Tip: A small pair of scissors is quite suitable).
-
Multimeter for voltage tests and for identifying the resistors.
-
A small hot air gun will be needed to shrink the heat shrink tubing
over the neon lamp wires.
2.2
Materials you will need.
Solder – lead / tin solder is highly recommended.
USE LEAD/ TIN SOLDER!
Lead free solder, as now required to be used in commercial products in
Europe, has a much higher melting point and can be very hard to work
with.
Desoldering wick (braid) can be useful if you accidentally create solder
bridges between adjacent solder joints.
2.3
Other items you will need.
The clock kit does not include a power adapter.
The following type of adapter should be obtained and used with the kit:
Output 12V DC regulated, minimum power output capability of 500mA
Output plug: 2.1mm pin, centre positive.
A suitable adapter is shown below:
