33
© 2008 Directed Electronics. All rights reserved.
Once the Program switch has been pressed and released the desired
number of times, press it once more and
HOLD
it. After a second,
the LED will flash to indicate which feature you have accessed. For
example, groups of eight flashes would indicate access to the status
output feature (Feature 8).
4.
Transmit.
The transmitter is used to select the
desired setting. As shipped, the unit is configured
to the LED ON settings. These are called the de-
fault settings. Pressing the button on the remote will cycle through the
available options in each feature.
5.
Release.
The Program switch can now be re-
leased.
You can advance from feature to feature by pressing and releasing the
Program switch the number of times necessary to get from the feature
you just programmed to the feature you wish to access. For example,
in Menu One, if you just programmed Feature 1-3 to off, and you next
want to program the next feature 1- 4, release the Program switch.
Press and release once to advance from Feature 1-3 to Feature 1-4.
Then press it once more and
HOLD
it. The LED will flash in groups of 4
to confirm that you have accessed Feature 1- 4.
The learn routine will be exited if any of the following occurs:
The ignition is turned on.
•
The Program switch is pressed too many times.
•
More than 25 seconds elapses between programming steps.
•
