Changing the world one Vehicle at a Time
d. Plug the receptacle (female) end of the charger power cable into the Pushpak charging outlet.
e. Plug the charger power cable into a standard household AC 110V outlet.12
NOTE: To protect the Pushpak from potential damage as a result of power surges, it is strongly
recommended that a surge protective device is used when plugging into a standard household AC 110V
outlet. Damage resulting from a power surge is not covered by the warranty.
f. Charger Light Indicators
When the charger power cable is plugged in, the charger box light will be activated.
1. A red light on the charger box indicates that the battery is not fully charged, but that there is a
proper connection, and the battery is receiving an electrical charge. Full charge can take up to 8
hours depending on the level of depletion in the battery.
2. A flashing green light on the charger box indicates that your Pushpak is nearly fully charged.
3. A solid green light on the charger box indicates you're your Pushpak is fully charged. Promptly
unplug the charger once the green light is displayed.
II.
BATTERY INFORMATION & SAFEGUARD
The lithium ion battery that comes with your Pushpak can last over 1000 charges or 2 to 3 years with
average use and proper care. Do not use the battery for any other purpose than to power your
Pushpak. Do not attempt to disassemble or modify the battery.
The battery is equipped with battery circuit protection which safeguards the battery from overcharging. If
any electrical functions on your Pushpak are not properly working, the battery
will automatically shut off. If this occurs, follow the steps below to reset your Pushpak:
a. Turn the ignition to the OFF position.
b. Turn the battery switch to the OFF position and then back to the ON position.
NOTE: Some Pushpak models do not have a battery switch. In this case, skip to step c. below.
c. To start your Pushpak, turn the ignition to the ON position.
20
