PURSUIT PRO9233Z, Installation And Reference Manual

Page: 12 / 19

PRO9233Z_RevA_08/20
12
Bank 2: Security Options
See pages 7-10 for detailed descriptions.
1 Chirp 2 Chirp 3 Chirp 4 Chirp 5 Chirp 6 Chirp
1 Lock / Unlock Func � on 500ms 3.5sec 500ms L, DBL UL DBL L, 500ms UL DBL L, DBL UL 500ms L, 350ms UL
2 Igni � on Lock OFF ON
3 Igni � on Unlock
OFF
ON
4 Auto Relock OFF Auto Lock Only Auto Lock & Arm
5 Auto Arming / Locking OFF Auto Arm Only Auto Lock & Arm
6 Door Trigger Instant Delay
7 1 or 2 Wire Disarm
2 Wire
1 Wire
8 No �fi ca � on Sound Both Siren Only Horn Only
9 Horn Timing 16ms 30ms 40ms 50ms 10ms
10 Valet Override Method Valet Custom Code
11 Security Pro fi le All On Doors O ff Hood/trunk O ff All O ff All ON w/ OEM RS
12 Data Port Protocol ADS DBI
13 Disarm Input 120ms Dr OR Pass 80ms Dr OR Pass 120ms, UL & Light 80ms, UL & Light
14 Arm 1 Input Auto Detect Posi � ve Nega � ve
15 Disarm 2 Input Auto Detect Posi � ve Nega � ve
16 Arm 2 Input
Auto Detect
Posi � ve Nega � ve
17 Disarm 2 Input Auto Detect Posi � ve Nega � ve
18 Trunk Shunt Input Auto Detect Posi � ve Nega � ve
19 Dome Light Delay Timer OFF / Program 15sec 30sec 45sec 60sec 120sec
20 Alarm Trigger Length 30sec 45sec 60sec 90sec 120sec
Feature Bank 2
Op � ons
Fe
at
ur
es
Data Port Protocol Selection
The default data port protocol of this model is ADS (iDatalink 2-Way). This model is capable of detecting the correct
data port protocol (ADS or DBI) and automatically configuring Feature Bank 2; Feature 12. To initialize the detection
procedure:
1. Press and hold the valet button.
2. Cycle the vehicle’s Ignition ON/OFF two (2) times.
3. Release the valet button.
Dome Light Delay
To program the Pursuit system to wait until the dome light turns off before arming:
1. Close all doors.
2. With the vehicle ignition off, press LOCK, UNLOCK, LOCK ,UNLOCK, LOCK, UNLOCK, LOCK on the remote control. The
dash-mounted LED will turn on.
2. Immediately OPEN then CLOSE the door WITHOUT disarming the system. After the dome light turns off, the LED will
flash to indicate programming completion.
3. Disarm and exit the vehicle.
To return the system to default dome light sensing:
1. Turn the vehicle ignition ON then OFF three (3) times, then press and hold the valet button for five (5) seconds.
2. The system will beep one (1) time indicating the learned delay has been cleared.
Quick Reference:
System Programming & Diagnostics