128-9489
Page 3
Page 3
Programming New or Replacement 171XPR or 1BER17XPR Transmitters:
1) Turn the ignition switch to the “On” position”
2) Press and release the pushbutton switch found on the windshield mount receiver 3 times.
(The LED on the receiver will flash).
3) Press and hold the transmitter start button, until the LED on the receiver turns solid.
4) Release the transmitter button. Programming is complete.
5) Repeat step 3 for all new or additional transmitters you want to operate your system up to a
total of four.
The above action programs the first 3 channels of the transmitter, or the start channel of the one
button transmitter, regardless of the number of buttons.
If you have lost a transmitter and want to insure it is no longer capable of operating your vehicle,
it is suggested that you erase all transmitters before recoding or adding any new ones.
For this action you will need all transmitters you want to control the system present before
proceeding.
To Erase All Transmitters:
1) Turn the ignition switch to the “On” position.
2) Press and release the pushbutton switch found on the windshield mount receiver 3 times.
(The LED on the receiver will flash).
3) Press and hold the push-button switch on the windshield receiver for 6 seconds. The LED
will flash 2X fast which is an indication all transmitters programmed to the system are now
erased.
4) Turn the ignition switch off.
Once you have erased all transmitters, you will have to go back and program all transmitters
that you want to operate your system.
Transmitter Battery Replacement
171XPR
1) Locate the slot at the lower right hand side of the transmitter case.
2) Separate the case halves by inserting a small plastic tool in the slot and carefully prying apart
the case halves.
3) Carefully slide the CR2032 battery out from under the battery clip and dispose of properly.
4) Insert a fresh CR2032 battery with the (+) side up away from the PCB.
5) Close the case in reverse order of disassembly
.
