PURSUIT 3370 OFFSHORE, Owner'S Manual

Page: 68 / 139

3370 OFFSHORE
68
Helm Seat
The helm seat is a pedestal seat that swivels and adjusts fore and aft. There are two levers and one tension
knob on the seat base. Lifting the lever located at the front of the seat base allows the seat to be adjusted fore
and aft. Releasing the lever locks the seat in that position. Lifting the lever on the port side of the seat base
releases the pivot lock and allows the helm seat to be swiveled on the pedestal. The helm seat will automatically
lock when it is swiveled back to the operating position. The friction knob adjusts the tension of the seat base
on the pedestal and is also located on the port side of the seat. It should be adjusted to allow the seat to be
swiveled when the swivel lock is released and tight enough to eliminate play between the seat base and the
pedestal.
Prep /Entertainment Center & Ice Maker
The prep/entertainment center is
equipped with a sink, storage
locker or optional ice maker, aft
facing folding seat and storage/
cooler area. The sink is plumbed
to the fresh water system and is
drained by gravity to a thru-hull
fitting in the hull side above the
waterline.
An AC ice maker is supplied as
optional equipment and is
mounted in the prep/entertain-
ment center. The ice maker op-
erates on AC power only. The
ice maker door has a special latch
to secure the door while under
way; make sure the door is prop-
erly secured whenever the boat is moving. Refer to the ice maker
owner’s manual for additional operating and maintenance instructions.
The fresh water system must be activated to supply water to the ice
maker.
Stern Bait Rigging Station
The stern bait rigging station is equipped with a transom
door, livewell, cutting board and tool holder. The sink is
plumbed to the fresh water system and drains overboard.
The livewell is supplied by a raw water circulating pump
and drains overboard. Refer to the Raw Water System
chapter for additional information on the livewell.
There is a tackle locker on the starboard side of the rigging
station that also provides access to the aft bilge. The tackle
locker is removed by opening the door, pulling forward on
the upper portion to release the magnetic latch, and lifting
up and out of the cavity. Increased access can be gained by
removing the screws from the lower keeper.
Stern Bait Rigging Station and Tackle Storage
Entertainment Center
Ice Maker