PURSUIT 3100 Offshore, Owner'S Manual

Page: 58 / 142

3100 OFFSHORE
58
The Washdown Pump Connector
The washdown pump hose connector is located in the cockpit and uses
a standard garden hose connection.
ALWAYS TURN THE RAW WATER PUMP SWITCH TO
THE “OFF” POSITION WHEN LEAVING THE BOAT
UNATTENDED.
DO NOT RUN THE HIGH PRESSURE PUMP DRY FOR EXTENDED PERIODS AS DAMAGE
TO THE PUMP WILL RESULT.
6.3 Livewell
Sea water is provided to the livewell by a 12-volt diaphragm pump. This pump is designed to carry a constant
flow of water to the livewell. The pump is activated by the livewell switch located in the cockpit panel. An
overflow built into the livewell automatically controls the water level in the livewell. Always turn the pump
off at the switch panel when the livewell is not in use. The livewell pump is equipped with a sea strainer on
the intake side of the sump located in the engine compartment.
To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure the valve
at the intake thru-hull fitting is open and activate the livewell switch. When the water level reaches the
overflow, it will begin to circulate.
To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the bottom of
the livewell. When the livewell has completely drained, use the washdown hose to flush the livewell and drain
debris. The livewell supply thru-hull valve should be closed whenever the livewell is not in use. This will
prevent water from entering the livewell while the boat is cruising.
DO NOT USE THE LIVEWELL AS A DRY STORAGE AREA WHEN IT IS NOT IN USE. SEA WATER
COULD ACCIDENTALLY BE DELIVERED TO THE LIVEWELL FROM THE THRU-HULL FIT-
TING AND DAMAGE EQUIPMENT STORED THERE.
Washdown Hose
Connector