www.purposeav.ca [email protected] (888) 470.2211
INSTALLATION
STEP 1: MOUNT WALL PLATE
Mounting on a Stud Wall (2 adjacent studs)
• Locate the center of the studs using a stud
finder and mark 4 holes
•
Pre-drill top and bottom holes into the
wood studs with a 7/32” drill bit to a depth
of 2.5”
• Fix the wall plate by using the lag bolt
screws (H) and washers (J) (Figure 2)
Mounting on a Concrete Wall
• Hold wall plate (A) against wall at the
desired position on a concrete wall, then
use a pencil to mark the four (4) positioned
holes.
• Drill holes where the pencil marks are
using a 3/8” size drill bit to a depth of 2.5”.
You will need to use wall anchors (I).
• Insert wall anchors (I) into holes. You may
need to use a hammer to lightly tap wall
anchors into the wall.
•
Then fix wall plate (A) to the wall with
screws (H) and washers (J). (Figure 1)
WARNING
Wood stud must be a minimum size of
2x4 inches. Lag bolts must be in the
center of the stud. Do not over tighten
lag bolts.
WARNING
Do not drill into mortar joints. Concrete
must be a minimum of 2000 psi density
in order to hold anchor. Ensure that the
anchor is flush with concrete surface
even if there is another layer of ma-
terial. If layer of material is over 3/8”,
custom thicker lag bolts must be used.
Do not over tighten lag bolts.
CAUTION
• The concrete wall minimum thickness no
less than 5.5 inches, and surface covering
can’t be more than 3/8 inches.
• Do not use it on concrete block.
