Purmo Analog Basic RF, User Manual

Page: 9 / 66

9
5 How to learn your RF thermostat with
the RF receiver
First of all, switch the button mode of the
thermostat in OFF position .
To learn (*) the RF thermostat with the receiver
you must put the receiver in “
RF init
” mode
(Please refer to the receiver leaflet).
Once, on the thermostat switch the button mode
on “
Automatic
” position
.
o
The thermostat will send now the RF signal to the
receiver. Check on the receiver the good
configuration.
o
If the RF learning is not made correctly, check the
installation (antenna connection, supply voltage...)
o
If the RF learning between the thermostat and the
receiver is good, put your thermostat in the off
mode .
o
On the receiver you can exit the “
RF init
” mode or
configure another thermostat. (Please refer to the
receiver leaflet for this)
Now you can check the RF distance, go to the
room which must be regulated. Put your
thermostat on the final position (On the wall
support or on the table support), then put the
thermostat on the Automatic mode (setting
temperature 30°C). Close the door and go to the
receiver to check if the new status of the
thermostat has received.