4
Installation & Operation Manual
Copyright © Puretec Ltd 2020
8. Restore the water supply and check for leaks.
9. Run the system for at least 5 minutes to remove carbon fines. Water may appear
milky, but this is normal and is only tiny air bubbles that will clear after a short period.
Cartridge Installation/Changeout
1. Rotate the old cartridge counterclockwise 1/4 turn, pull it out and dispose of it.
2. Remove all packaging from the new cartridge, including any wraps or caps (if
applicable).
Replacement cartridge:
Z1-R
3. Insert the new cartridge into the filter head and rotate clockwise 1/4 turn.
4. If you have an LED indicator on your faucet or 3-way mixer, reset it according to the
model instructions.
5. Turn on the water and check for leaks. If leaks occur, repeat step 3. If leaks persist,
discontinue use and call your supporting dealer.
6. Flush filter for 5 minutes before use or until water runs clear.
Use Guidelines
•
Minimum operating pressure 200 kPa.
•
Maximum operating pressure 520 kPa.
•
Do not allow exposure to temperatures below 0 °C, protect from freezing.
•
Maximum operating temperature 38 °C (protect from freezing).
•
Nominal flow rate 5.5 Lpm.
•
This system must be installed according to local plumbing codes on the cold water line
- mains only.
•
Replacement Cartridge:
Z1-R
•
This system requires regular replacement of the filter cartridge to maintain proper
operation. Varying chlorine, sediment, or organic substance levels may affect
replacement frequency.
•
Be sure to change the filter cartridge at least every 23,000 litres or 6 - 12 months
which ever occurs first; or whenever you detect a change in taste, odour, or decrease in
flow.
Installation
