(1) P20KW / P30KW Air Dryer
(2) 10’ sections of 3/8” Drain Tubing
(1) Installation Guide (not shown)
Package located inside the dryer:
(1) Alarm Plug
(1) Water Sensor
(1) Compressor Connector Tool
(1) User’s Guide - Paper copy or digital fi le on CD (not shown)
• Large adjustable wrench
• Medium adjustable wrench
• Band cutters or snips
• 3/8” wrench
• 7/16” wrench
• 1/2” wrench
• Small fl at head screwdriver
• Medium fl at head screwdriver
• Medium phillips head screwdriver
• 1+ gallon of clean tap water
(DO NOT USE DISTILLTED WATER)
• Pipe dope or pipe thread tape
• Shop towels
• Cup of soapy water
• 1-inch paint brush (recommended)
Required Tools and Materials
Included Contents
Installation Steps
• Remove all shipping materials.
• Place the dryer at the operating location.
1
Remove the shipping blocks:
• Using a 1/2” wrench, loosen the nuts on the
RRU Compressor.
• Remove and discard the shipping blocks
from under the RRU Compressor.
• Retighten the RRU Compressor nuts.
• Using a 7/16” wrench, remove bolt and
block from under the compressor plate.
• Discard block and bolt.
5
• Remove the ship-loose contents package.
4
• Remove the Lower Front and Side Panels.
2
• Check for loose parts, hoses, or wiring.
NOTE
: If ANY SHIPPING DAMAGE is detected,
fi le a claim with the shipping company prior to
continuing the installation procedures.
3
• Install 3/8” drain tubing to primary and
secondary fi ttings and route to an
unobstucted drain or bucket.
NOTE
: DO NOT PLUMB DRYERS TOGETHER.
6
• Verify that the dryer is powered
OFF
.
7