ADJUSTABLE
MOUNTING BAR
STUD
#8 SCREW
JUNCTION
BOX
CONDUIT W/
LOW-VOLTAGE WIRES
1
1:
Remove the lens from the Center Feed Power connector.
2:
Remove the #4-40 screw from the junction box using a 1/16"
Allen wrench to remove the trap door from the assembly.
3:
Remove the two #4-40 screws from the junction box using
a 1/16" Allen wrench to remove the Center Feed Power
Connector assembly.
JUNCTION
BOX
ADJUSTABLE
MOUNTING BAR
MOUNTING
BRACKET
PHILLIPS
SCREW
ADJUSTABLE
MOUNTING BAR
MOUNTING
BRACKET
PHILLIPS
SCREW
Section One: Install the Junction Box
SAVE THESE INSTRUCTIONS!
- This instruction must be used concurrently with other
TruLine 1A BIY installation instructions.
- This product is wall or ceiling mount.
- This instruction shows a typical installation.
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 902-TL1A-CFP_04
Installation Instructions for
TruLine 1A Center Feed Power Channel Connector
A
HORIZONTAL ORIENTATION
VERTICAL ORIENTATION
4:
Mount each adjustable mounting bar to one side of the junction box and secure them with the mounting brackets and two
Phillips screws provided.
JUNCTION
BOX
5:
Place the lips on the adjustable mounting bars against the
studs. Secure the adjustable bars to the studs with the #8
screws.
6:
Install conduit(s) (if required by local electrical code) and
run low voltage wires to the junction box.
NOTE:
The adjustable mounting bars mount to studs that are
spaced 13" to 24" apart.
B
C
D
4
4
5
6
#4-40
SCREW
JUNCTION
BOX
1
LENS
2
#4-40 SCREW
CENTER FEED
POWER CONNECTOR
TRAP
DOOR
3
3
JUNCTION
BOX
