2MM ALLEN
WRENCH
14
COAXIAL
CABLE
M4 SET
SCREW
14:
Use the provided 2mm Allen wrench to securely tighten the
M4 set screw until it squeezes the wire ferrule tightly to the
coaxial cable.
P
15:
Replace the coaxial connector cover and tighten into
place.
16:
Repeat steps 4 through 15 for connecting the other coaxial
cable.
Q
15
COAXIAL
CONNECTOR
COVER
COAXIAL
CABLE
NOTE:
Ensure remote power supply wires are present in the
junction box. Refer to instructions provided with the power
supply.
NOTE:
If using 2" Round or Square Canopy, refer to the
instructions provided with the canopy to install the junction box
with 2" plaster ring.
For 4" Canopy:
17:
Feed the low voltage wires from the power supplies
through the crossbar center hole.
18:
Mount the crossbar to the junction box holes with two
#8-32 screws.
For Both 2" Canopy and 4" Canopy:
19:
Connect the red wire from one coaxial connector to a +24VDC power supply wire with a wire nut.
20:
Connect the black wire of the same coaxial connector to the -24VDC wire of the same power supply with a wire nut.
21:
Repeat steps 19 and 20 for the other coaxial connector and power supply.
22:
Place all connections inside the junction box.
22
JUNCTION
BOX
COAXIAL
CONNECTOR
20
21
19
5
22
JUNCTION
BOX
COAXIAL
CONNECTOR
20
21
19
R
17
#8-32
SCREW
18
CROSSBAR
JUNCTION
BOX
S
