6
Battery Power:
You may also use 4 AA batteries to power the massage
unit, which will give you approximately 3 hours of
continuous massage time.
1. Remove the battery compartment cover on the back
of the remote
2. Place 4 AA batteries in the remote.
3. Press and hold the
ON/OFF
button
on the front
of the remote for 2 seconds.
4. Ensure that you do not have both sources of power
connected at one time.
To Fit the Massager to your Head:
1. Place the massager on your head with the eyeholes in front of your eyes.
2. Turn the fitting knobs on each side of the massager clockwise to tighten, or
counterclockwise to loosen. The massager should fit snugly around your head.
3. Turn the tightening knob on the top of the massager clockwise to shorten or
counterclockwise to lengthen the rise of the massager. You will know you have
the correct fit when the massager does not fall off when you move slightly,
and you can see out of the eyesight holes.
Note: Each time the massager is powered off, the default settings are restored once the massager is powered on the next
time. It is normal for the massager to move for a cycle, about 2 seconds, upon every shutdown or startup.
To Power On:
1. Ensure you have plugged the power adapter into an
appropriate wall outlet, and into the DC jack on the
remote.
2. Place the massager on your head.
3. Ensure proper fit.
4. Press and hold the
ON/OFF
button
on the front of
the remote for 2 seconds.
5. The LED screen on the remote will light up and the AUTO
massage mode will begin.
6. You will now have the option to choose massage
functions or intensity settings. (See MASSAGE CONTROLS
on Pg. 7)
7. To Turn off the massager at any time, press and hold the
ON/OFF
button for 2 seconds again.
FITTING THE MASSAGER
POWERING ON
