64-95 GOBO
2
96-127 GOBO
3
128-159 GOBO
4
160-191 GOBO
5
192-223 GOBO
6
WHEEL
224-255 GOBO
7
0-149
Step rotation in anti-clockwise direction (0-540°)
150-153
Stop (Position in 540°)
154-201
Rotate from slow to fast in clockwise direction
202-207 Stop
9
GOBO ROTATION
208-255
Rotate from slow to fast in anti-clockwise direction
0-7
No prism (white)
8-15 Prism
static
16-106
Rotate from fast to slow in anti-clockwise direction
107-110 Stop
111-199
Rotate from slow to fast in clockwise direction
200-204
Rotate slowly in anti-clockwise direction
205-209 Macro
1
210-214 Macro
2
215-219 Macro
3
220-224 Macro
4
225-229 Macro
5
230-234 Macro
6
235-239 Macro
7
240-244 Macro
8
245-249 Macro
9
10
PRISM
250-255 Macro
10
0-50 White
51-101
Effect 1 (15.6°)
102-152
Effect 2 (19.5°)
153-203
Colour temperature glass 1 (3200°K)
11
EFFECT WHEEL
204-255
Colour temperature glass 2 (7800°K)
12 X/Y SPEED
0-255
Pan and tilt movement from slow to fast
13 PAN 16Bit
0-255
Pan 16Bit resolution
14 TILT 16Bit
0-255
Tilt 16Bit resolution
0-109 Not
used
110-119 Lamp
off
120-159 Not
used
160-179
Lamp on (It can’t be on until after 10 minutes of lamp off)
180-219 Not
used
220-239 Reset
15
LAMP CONTROL
AND RESET
240-255 Not
used
NOTE:
1. After turning the lamp off, the “L. Hot” characters may be appeared on the display screen meaning
the lamp should be cooled for 10 minutes before it can restart. If the lamp is still not lit after being
switched on, the luminaire will attempt to restart the lamp automatically at intervals of 10 minutes. After
8 times of restarting, if the lamp is still off, it means the lamp is damaged and the “L. Err” appears on
the display screen.
2. The speed of fans may be adjusted automatically in relation to the temperature inside the luminaire.
3. Channels 13 and 14 – high resolution Pan and Tilt, are only available if the 16 Bit Resolution option
has been set to ON in the setup options of the projector.
4. Channel 15 - Lamp Control and Reset is only available if the appropriate options have been set to
ON in the setup options of the projector.
Soft Reset
– If the option rErE is set to OFF this reset function will be available on channel 3, the
colour channel. If the DMX value sent on this channel (3) stays in the range from 5 to 7 for more than
5 seconds, the projector will start a reset sequence (Remote Requested Soft Reset). The electronics
are re-started and all motors moved to their home positions exactly as they do when the power is first
switched on but the lamp is not switched off in this sequence, although the beam will be blacked out.
Press the UP or DOWN button to select
(self test), and then press ENTER button to confirm
it. The projector will run in stand-alone mode automatically with a programme that has been factory set.
STAND-ALONE MODE
PILOT250manualEN.doc
9/16
