STEP 3: Seesaw Base Assembly
WARNING: To avoid your fingers becoming caught during assembly,
you must attach the bolts only as noted below.
A. Attach 2x Seesaw Legs (L) to the Lower Support Tube:
Using 2x M6 110mm Bolts, 4x M6 Washers, 4x M6 Lock Washers, and 2x Nuts attach 2 Legs (L) to the Lower
Support Tube (J) as shown in the diagram. NOTE: The (L) Legs must go into the
upper
pair of pre-drilled Bolt
Holes in the Support Tube.
B. Attach remaining 2x Seesaw Legs (O) to the Lower Support Tube:
Using 2x M6 110mm Bolts, 4x M6 Washers, 4x M6 Lock Washers, and 2x Nuts attach 2 Legs (O) to the Lower
Support Tube (J) as shown in the diagram. NOTE: The (O) Legs must go into the
lower
pair of pre-drilled Bolt
Holes in the Support Tube.
STEP 4: Swivel Assembly
A. Attach the Swivel to the Main Bar:
First slide the Plastic Tube (W) onto the end of the Upper Support Swivel (I).
Next, line up the Upper Sup-
port to the Hole in the center of the Main Bar. Secure the Swivel to the Main Bar using the 70mm Hex Bolt (C),
2x M8 Washers (S), 1x M8 Lock Washer (T), and 1x M8 Nut (U).
B. Join the Upper and Lower Assemblies:
Insert the completed Main Bar Assembly into the Seesaw Base Assembly. Ensure the Plastic Tube (W) re-
mains securely affixed. Lastly, insert a Plastic Cap (X) into each Leg End.
