STEP 2:
A.
Insert the Left Upright Support (3) into the Left
(when facing the unit) Central Support Tube.
B.
Locate 2x M10x58 Bolts and slide an Arc Washer
on each of these Bolts. Again, make sure that the
curve on the Washer will match that of the tube.
C.
Loosely secure these Bolts, but do not fully tight-
en.
Repeat the above steps for the Right Upright
Support (4).
DO NOT FULLY TIGHTEN BOLTS UNTIL
STEP 3
STEP 3:
A.
Attach the Lat Bar (5) to the Left and Right Up-
right Supports as shown on the right.
B.
Locate 2x M10x55 Bolts (14) and place an Arc
Washer (15) on each Bolt.
C.
You may have to adjust the positioning of the Up-
right Support Tube(s) to get the Lat Bar to securely
fit.
D.
Once you have threaded the Bolts into the holes,
fully secure this attachment.
E.
Locate the Bolts from Steps 1 and 2 and FULLY
TIGHTEN and SECURE these connections now.
IMPORTANT: ENSURE ALL BOLTS ARE
FULLY TIGHTENED BEFORE CONTINUING
ASSEMBLY INSTRUCTIONS (CONTINUED)
