11
10
CLEANING & MAINTENANCE
Changing the Activated Carbon Pre-Filter
1. Release the inlet grill by pressing on the locking latch (see the
product diagram on Page 7).
2. Remove the inlet grill from the unit.
3. Grasp the pre-filter from the backside of the inlet grill and
remove the pre-filter.
4. Insert new Pre-filter into the inlet grill.
5. Reattach the inlet grill and secure the locking latch into place.
6. Press and hold the Timer and UV buttons at the same time for 3
seconds to reset the Filter Change Indicator.
Cleaning External Surfaces
1. Turn off and unplug the air purifier.
2. Use a washcloth, slightly dampened with water and dishwashing
soap, to wipe the outer case surfaces.
3. DO NOT allow water to slip into the internal parts as this could
damage the product and result in electrical shock and injury.
4. Allow the air purifier to thoroughly dry before use.
UV Lamp Maintenance
The UV lamp is designed to provide up to 12 months of continuous,
effective operation. After this time, the bulb may remain illuminated,
but its effectiveness will be reduced. For maximum effectiveness,
please replace the UV bulb annually.
If the lamp stops functioning or needs replacement, visit our
website at pureenrichment.com to order a replacement lamp.
Caution:
•
DO NOT touch the glass part of the lamp. Oil from fingertips will
decrease the effectiveness of the lamp.
•
Never operate the air purifier without a filter or with a damaged
filter. The UV lamp cover must be installed at all times. The UV
light from the UV lamp will result in severe damage to eyes and
could cause blindness.
CLEANING & MAINTENANCE
To keep your air purifier functioning properly, we recommend
changing the True HEPA filter and activated carbon pre-filter after
approximately 6 months of usage. More frequent changing will
be necessary if the product is used in an area with a high level of
airborne contaminants (such as excessive amounts of smoke, pet
dander, etc.). Exposing the product to candle/oil/fireplace and smoke
is not recommended and will require more frequent maintenance.
NOTE: ALWAYS MAKE SURE THE AIR PURIFIER IS TURNED
OFF AND UNPLUGGED BEFORE THE CHANGING FILTER OR
CLEANING.
•
DO NOT use water or any household cleaners or detergents
to clean the True HEPA filter.
•
The inlet grill may be cleaned (after the unit is turned off and
unplugged) with a vacuum or a slightly damp cloth.
Changing the True HEPA Filter
1. Release the inlet grill by pressing on the locking latch (see the
product diagram on Page 7).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the left and right frames of the True HEPA Filter through
the indentations on the sides of the filter enclosure and remove
the filter.
4. Insert the new True HEPA Filter. Make sure it is facing the
correct direction.
5. Reattach the inlet grill and secure the locking latch into place.
6. Press and hold the Timer and UV buttons at the same time for 3
seconds to reset the Filter Change Indicator.
