4
5
INSTALLATION GUIDE
1. Screw two of the speaker brackets to each of the speakers in the pre-drilled holes provided
2. Select a suitable position for each of the speaker either side of the Interactive whiteboard.
3. Fix one of the wall mounting screws into a suitable wall plug in the wall in a position so
that the speaker can be hung on this screw using the central
“
keyhole
”
wall mount. Hang
the speaker unit on this fixing and mark a hole position on the wall for the position of the top
speaker security bracket.
4. Drill and install a suitable wall plug for the top security bracket.
5. Hang the speakers using the central
“
Keyhole
”
wall mount and secure the speaker to the
wall with the screws provided into the top wall plug position.
6. Connect the 10m speaker cable provided into the active speaker using the RCA connector
in the base of the Active speaker. Measure and cut the raw end of the cable to the length
required to join the passive speaker to the amplifier. Strip off 7mm of insulation from the cut
end and insert into the speaker connections on the passive speaker
7. Fix the wired remote control to a suitable position on the wall using the adhesive pad
provided
8. Connect the Audio cables with RCA connectors into the rear of the active speaker unit and
into the audio sources (or cable termination box if used)
9. Check that both the on/off switch and the Volume control on the wired remote control
switched off. Plug the power cable to the mains supply and switch the supply on.
10.Follow the Operating Instructions below
Amplifier Panel
Passive Spear Rear View
Connections Passive Speaker
1. Bare wire connectors are provided on the passive speaker to enable the passive speaker to
be connected up to 10 metres away from the amplifier by cutting the the speaker cable to the
length required.
