![PUR PQC1FS Owner'S Manual Download Page 8](http://html.mh-extra.com/html/pur/pqc1fs/pqc1fs_owners-manual_1625991008.webp)
7
Filter Cartridge Replacement Instructions:
Start-up Instructions:
1.
Turn Inlet Valve (G) to open position and the cold water sink Faucet to the closed position. (Figure 7)
2.
Slowly open the cold water supply valve that you closed at the beginning of this installation.
3.
Open Faucet (I) to purge air from the system. When the water runs smooth with no bubbles or spurting, close the Faucet and
check for leaks for all fittings.
4.
Open the Faucet (I) again to rinse the system.
CAUTION: Let water run 15 minutes before using.
NOTE: Initially, there may be some dark discoloration of the water (carbon deposits). This condition is
normal and will disappear quickly.
1.
Turn off Inlet Valve (G), and open Faucet (I) to relieve pressure from the system. Place a tray or towel under Filter Housing (B
and C) to catch excess water.
To replace filter for PQC1FS:
2.
Follow the instruction of “Un-installing the Quick-Connect Filter” on Page 3 to remove old filter.
3.
Then, follow the instruction of “Installing the Quick-Connect Filter” on Page 3 to install new filter. Then go to step 5 below.
To replace filter for PQC2FS:
2.
Follow the instruction of “Un-installing the Quick-Connect Filter” on Page 3 to remove old filters.
3.
Then, follow the instruction of “Installing the Quick-Connect Filter” on Page 3 to install new filters.
4.
Make sure Sediment Filter (B, yellow dot) is installed to Inlet side of the system and Carbon Block Filter (C, green dot) is to
outlet side of the system. Then go to step 5 below.
CAUTION: When looking at the system from the front, the Sediment Filter must be on the left and Carbon
Block Filter must be on the right.
5.
Slowly open Inlet Valve (G) that you turned off at the beginning of this instruction.
6.
Open the Faucet (I) to purge air from the system. When the water runs smooth with no bubbles or spurting, close the Faucet
and check for leaks. If any leaks, re-install the housing as needed.
7.
Open the Faucet (I) again to rinse the system.
CAUTION: Let water run 15 minutes before using.
NOTE: Changes in taste, odor, color and/or flow of the filtered water may indicate that the cartridge should
be replaced.
Filters
must
be replaced periodically. Refer to the replacement schedule above.
Depending on which model was purchased, the chart below will assist with replacement of filters. The replacement filter can be
obtained online at www.ghpgroupinc.com or at the retail store where the system was purchased.
Periodic System Maintenance:
Model #
Filter Replacement Kit -
Replace every 6 months
PQC1FS
PQCCRBKIT (contains: 2x PQCCRB)
PQC2FS
PQC2FSKIT (contains: 1x PQCCRBL, 1x PQCSED)