6. This product should be located away from heat sources such as radiators, heat registers or other
products that produce heat.
7. The product should be connected to a power supply only of the type described on the operating
instructions or as marked on the product. Always ensure that a good quality mains lead is used
applicable for your country. The following wiring convention is used in all product mains leads, and
must be strictly observed: Green & Yellow = Earth. Brown = Live. Blue = Neutral. IMPORTANT: THIS
UNIT MUST BE EARTHED!
8. If the mains fuse need replacing, DISCONNECT THE PRODUCT FROM THE MAINS SUPPLY.
The fuse is above the mains IEC socket, and must be replaced with a fuse of the type and rating
stated on the rear panel. If a replacement fuse fails immediately, contact your local service agent. DO
NOT replace with a higher value.
9. The power-supply cord of the product should be unplugged from the outlet when left unused for a
long period of time. When unplugging the power-supply cord, DO NOT pull on the cord, but grasp it by
the plug.
10. Ensure the mains isolation switch is readily accessible when the product is in use.
11. Care should be taken so that objects do not fall and liquids are not spilled into the enclosure
through openings.
12. The product should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged; or
B. Object have fallen, or liquid has been spilled into the product; or
C. The product has been exposed to rain; or
D. The product does not appear to operate normally or exhibits a marked change in performance; or
E. The product has been dropped or the enclosure damaged.
14. DO NOT attempt to service the product beyond that described in the user-maintenance
instructions. All other servicing should be referred to qualified service personnel.
15. WARNING -DO NOT place objects on the product’s power cord or place it in a position where
anyone could trip over, walk on or roll anything over it. DO NOT allow the product to rest on or to be
installed over power cords of any type. Improper installations of this type create the possibility of fire
hazard and/or personal injury.
IF YOUR AMP STOPS WORKING ;
IF YOUR AMP STOPS WORKING ;
IF YOUR AMP STOPS WORKING ;
IF YOUR AMP STOPS WORKING ;
•
READ THE MANUAL !!!
•
Turn volume to zero on both channels
•
Check all connections (input and output, at both ends of cable)
•
Check status lights on front panel
•
Disconnect from mains before changing fuse
•
Replace fuse only with same type and rating