Pulse APA200 User Manual Download Page 4

www.pulse-audio.co.uk

 | APA Series User Manual 

 

OPERATION 

 

 

 

 

 

 

 

 

 

 

 

 

 

MAINTENANCE 

 

No user serviceable parts inside, refer all servicing issues to qualified service personnel.  
Clean case with a lint-free dry or slightly damp cloth, keep ventilation grille and fans clear of debris. 
 

TROUBLESHOOTING 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Errors and omissions excepted.  

Copyright© 2014. Pulse 

  Check mains for correct voltage as indicated near to the IEC mains inlet on the rear panel. Connect to mains 

supply using the IEC cable provided.  

  Connect the outputs A+B to speakers via speaker connectors, jack or binding posts, ensuring that the minimum 

impedance is no lower than 4  per channel 

  When using 8  speakers, connect the speakers in pairs to each other and then connect one of each pair to an 

amplifier channel output. 

  Connect the mixer or audio source to either the combo or RCA input sockets 
  With channel A+B levels down, switch the power on. 
  Gradually increase channel levels and check for sound from speakers. 
  If there is no sound, turn down channel levels, switch off and disconnect mains and check connections   if front 

panel PROTECT LEDs are lit, refer to qualified service personnel. 

NO OUTPUT -  

Check mains power is on and fuse is OK 

Check leads and connections 

Check PROTECT LEDs are not lit 

Check speakers are working on another amplifier 

DISTORTED OUTPUT -  

Check the total speaker impedance is not below 4Ω per channel

Turn down the input level from audio source

Check audio source file being played is not distorted

Turn down channel gain controls

 

 

If protect mode is active, refer to qualified service personnel

 

Reviews: