7
Usage
Pressure Balance Mixing Valve
This ShowerSpa is equipped with a cUPC® pressure balance mixing valve to adjust water flow and temperature.
The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet), keeping your temperature
constant and preventing accidental scalding. To turn on the ShowerSpa simply raise the handle until the desired flow
rate is achieved. Rotate to the right to decrease temperature and rotate to the left to increase temperature. Be sure
that the handle is in the OFF position when you are done using your ShowerSpa so that pressure does not build up
inside the unit.
Diverters
This Showerspa offers independent control of each function. Water pressure can be directed to a single function
or split between the different functions via the five diverter knobs (located on the side of the ShowerSpa). The five
functions are rain showerhead, waterfall showerhead, handshower and two body jet functions. To turn a function
on, simply rotate the knob until the desired flow rate is achieved. Rotate the knob in the reverse direction to turn the
function off.
IMPORTANT— DO NOT
turn off the ShowerSpa by rotating all diverters to the off position. You must shut off the
Mixing Valve when done showering. If you do not, water pressure may build up inside the unit, causing
leaks that may enter your wall.
Showerheads
There are two separate showerhead functions that are controlled independently. Each has its' own diverter knob. You
may concentrate all pressure to one function or spread between the two. The rain showerhead provides the relaxing
feel of soft rain while the waterfall showerhead is a single wide stream that offers more direct pressure.
Body Jets
This ShowerSpa is equipped with three oversized body jets. Each jet can be adjusted slightly to change the angle of
spray by pressing near the edges. There are two separate knobs controlling the body jets. The first knob operates the
two upper jets, while the other knob controls the lower jet. Again, you may concentrate all pressure to one function or
spread between the two.
Handshower
The handshower has a single power-spray pattern that can be used alone or in combination with any of the other
ShowerSpa functions.
Care and Maintenance
Always blot dry any water from the surface of your ShowerSpa. To protect your ShowerSpa from hard water
stains and mineral deposits, use an auto spray wax periodically and wipe down your ShowerSpa after each use.
Allowing water to evaporate on the surface can lead to a buildup of mineral deposits. Cleaning with a damp,
nonabrasive sponge and drying with a clean soft cloth should help keep your ShowerSpa looking beautiful.
R E M E M B E R
NEVER use any abrasives or harsh cleaners!
Clean with mild soap and water ONLY!
To keep your ShowerSpa in pristine condition,
DRY AFTER EACH USE!
