000
000
1.
Valve Body
2-8. Integral Stop/Shuto
ff
Assembly
9. Pressure Balanced Cartridge
10. Limit Stop
11. Valve Sleeve
12. Trim Sleeve
13. Trim Nut
14. Valve Handle
15. Set Screw
16. Set Screw Cover
17. Friction Ring
18. Trim Plate
19. Plaster Guard
20. Tub Spout Cap
21. Wall Gasket/ Sealer
22. Hot Water Inlet
23. Cold Water Inlet
24. Water Power Generator
25. Tub Spout Outlet
26. LED Display
27. Water Power Generator
28. Gasket
29. LED Connector
30. Snap On LED Housing
Parts Legend
Installation
Valve Installation/Replacing Existing Valve
1. TURN OFF WATER SUPPLY TO SHOWER. Typically there is a gate valve where the water main enters the
house. Turning the water valve o
ff
at hot water tank does not turn o
ff
cold water supply line.
2. Make certain water is completely turned o
ff
to both hot & cold supply lines of shower. Turn shower valve
on, both hot and cold, to VERIFY WATER SUPPLY IS OFF. Open a sink faucet in bathroom in which you are
installing valve to relieve any pressure and help adequately drain shower supply lines.
3. Remove handle(s) and trim cover(s) of your existing shower valve, exposing valve body in wall.
4. Locate hot and cold supply lines entering valve. Using a reciprocating saw with sharp metal saw blade and cut
existing valve out. You should also cut riser within wall supplying existing shower head. Carefully twist and
remove valve.
5. Install valve, MAKING SURE WATER POWERED GENERATOR AND "UP" OUTLET IS FACING UP and secure
to wall framing with screws (not included). Plaster guard (19) must be
fl
ush with
fi
nished wall for
proper positioning. Connect water supplies to valve (hot water to left side and cold water to right side).
Use thread seal compound or plumber's tape on all threaded connections to prevent leaks.
Some soldering of joints and
fi
ttings may be necessary for copper pipes.
6. Connect riser pipe and tub spout outlet plumbing. If you have a shower only model, you will need to cap
valve's tub outlet with supplied cap (20). Likewise if you have a tub only model, you will need to cap valve's
shower outlet. Do not attach showerhead until after
fl
ushing the shower's riser pipe.
7. Step 1: Remove black gasket (28).
Step 2: Lift to release side lock and separate LED box and snap on LED housing (30).
Step 3: From the front of the trim (18) insert connector cable (29) and LED display (26)
through the trim LED window. NOTE: Make sure the circles on the LED Display (26) are facing down.
Step 4: Place gasket (28) on the back of the trim (18) onto LED display (26).
Step5: Place snap on LED housing (30) onto LED display (26) through the back and snap on to lock in place.
Step 6: Connect LED display (26) to water power generator (24) on valve.
8. Remove plaster guard (19). Install nylon friction ring (17) and wall gasket (21) to trim plate (18). Align trim
plate with LED display and slide over valve assembly. Install handle (14) and tighten set screw (15).
NOTE: Make sure you follow the UP and DOWN arrows on the valve body (1) for correct placement.
000
Cold water at 78°F and below
Warm water at 79°F to 96°F
Hot water at 97°F and above
