Pulsar VD73 Manual Download Page 6

English

English

11

10

*  Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the 

crown is pushed in completely.

  Do not operate the crown when the watch is wet or in water.  If used in sea water, 

rinse the watch in fresh water and dry it completely.

*  When taking a shower with the water resistance 5 bar watch, or taking a bath with 

the water resistance 10, 15 or 20 bar watch, be sure to observe the following:

 

  Do not operate the crown when the watch is wet.

 

  If the watch is left in warm water, a slight time loss or gain may be caused.  This 

condition, however, will be corrected when the watch returns to normal tem-

perature.

NOTE:
Pressure in bar is a test pressure and should not be considered as cor-
responding to actual diving depth since swimming movement tends to 
increase the pressure at a given depth.  Care should also be taken on 
diving into water.

TEMPERATURES

Temperatures over 50° C (122° F) 

may cause battery leakage or short-

Your watch works with 

stable accuracy within a 

temperature range of 5

° C and 35° C (41° F and 

95° F).

en the battery life.  Do not leave 

your watch in very low temperatures 

below –5° C (+23° F) for a long time 

since the cold may cause a slight 

time loss or gain.

However, the above conditions will 

be corrected when the watch returns 

to normal temperature.

MAGNETISM

Your watch will be ad-

versely affected by strong 

magnetism.  Keep it away 

from close contact with 

magnetic objects.

Be careful not to expose 

the watch to solvents, 

mercury, cosmetic spray, 

detergents, adhesives or 

paints.  Otherwise, the 

CHEMICALS

case, bracelet, etc. may become 

discolored, deteriorated or dam-

aged.

Light activities will not 

affect your watch, but be 

careful not to drop your 

watch or hit it against 

hard surfaces, as this 

SHOCKS & VIBRATION

may cause damage.

To prevent possible rusting of 

the case and bracelet caused 

by dust, moisture and perspi-

ration, wipe them periodically 

with a soft dry cloth.

CARE OF CASE AND BRACELET

It is recommended that the 

watch be checked once 

every 2 to 3 years.  Have 

your watch checked by an 

AUTHORIZED PULSAR 

PERIODIC CHECK

DEALER or SER VICE CENTER to 

ensure that the case, crown, buttons, 

gasket and crystal seal remain intact.

PRECAUTION REGARDING 

CASE BACK PROTECTIVE FILM

If your watch has a protec-

tive film and/or a sticker on 

the case back, be sure to 

peel them off before using 

your watch.

Reviews: