www.pulsar.pl
RUPS812T
RACK POWER
6
2.2. Installation procedure.
1. Before installation, cut off the voltage in the 230V power-supply circuit.
2. Mount the power supply in a RACK 19" cabinet as shown below:
- Mount M6 cage nuts
- Secure the enclosure with 4xM6 screws
3. Connect the receivers’ cables to the terminals AUX1...AUX8.
4. If needed, the following technical connections can be made:
- ALARM – technical output of collective failure
5. Connect the battery to the +BAT- terminals:
- battery output (V+): terminal BAT+
- battery output (V-): terminal BAT-
6. Connect the ~230V AC power cord with the IEC C13 plug (included) to the 230V AC power supply and turn on the
power (~230V).
7. Check the PSU operation indicator.
3. Operating status indication.
3.1. LED indication.
The PSU has 13 LED lights at the front panel:
GREEN LED:
•
on – the PSU is supplied with 230V AC
•
off – no 230V AC supply
GREEN LED:
•
on – DC voltage at the output of the switch mode PSU
•
off – no DC voltage at the output of the switch mode PSU
RED LED:
•
on – failure
•
off – no failure
RED LED:
•
ON – too high temperature of the switch mode power supply
(>70°C)
•
OFF – standard temperature of the switch mode power supply
RED LED:
•
on – battery voltage <11,5V
•
off – battery voltage >11,5V
GREEN LED:
•
on – DC voltage in the AUX1…AUX8 output
•
off – no DC voltage in the AUX1…AUX8 output
