8
Step 3
Attach the hose connector to pressure washer. Before attaching the connector to the male
fitting, remove the plastic cap, which is inserted onto the male fitting on the pressure washer
before shipping. This plastic cap can be discarded once removed. After both components have
been installed, attach the garden hose with connector screw on the pressure washer. Connect
the garden hose to the waterspout.
2000 PSI Pressure Washer
OPERATING INSTRUCTIONS
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE WASHER!
Starting Up
After connecting the pressure washer to your cold
water supply, proceed as follows:
-
Make sure that the on/off switch is
in the off position.
-
Connect the garden hose with a quick
connect to the inlet fitting.
-
Attach the hose to the gun as per
assembly instruction step #1.
-
Insert the adjustable spray nozzle
into the gun as per assembly step
#2.
2000 PSI Pressure Washer
9
-
Connect the high pressure hose to
the high pressure outlet fitting as
per assembly step #3.
-
Open the water supply valve completely.
-
Before turning the unit on, press the gun trigger to bleed all the
remaining air out of the pump and hose.
-
Start the pressure washer by turning the on/off switch to the
on position and squeeze the trigger.
REMINDER:
m
The otor does not run continuously,only when the trigger is squeezed.
WARNING – Risk injury the unit will start spraying
when trigger is squeezed. When turning the unit off after
use, high pressure still exists inside the hose and unit. Point
the gun in a safe direction and discharge the excess
pressure. NEVER direct the high pressure water stream at
people or animals.
Automatic On / Off
The pressure washer is equipped with an automatic on/off switch.The pressure washer
will only run when the power switch is in the ON position and the trigger on the gun is
squeezed. When you release the trigger to stop spraying water through the gun, the
motor on the pressure washer will automatically shut off. Simply squeeze the trigger
again to resume using the washer. To stop using the pressure washer, release the
trigger and switch the unit to the OFF position. The unit should be turned completely
OFF while not in use or while unattended.
Bleeding The Gun
It is very important to bleed all the air out of the pressure washer before using it.To do this
1. Release trigger lock.
2. Squeeze the trigger before turning the electrical supply on.This removes any air trapped
inside the pressure washer and lance before using the units.
3. Continue holding trigger for approximately one minute to allow any excess air out of the
unit.Water will flow through the gun at low pressure during this procedure.
4. Lock the trigger.
5. Plug the power cord into the electrical outlet.
6. Release the trigger lock.
7. Turn the ON/OFF switch clockwise to the I/ON position.
The pressure washer is ready for operation.
