Pulsar GREEN POWER CCTV PoE POE044816 Manual Download Page 8

Page: 8 / 8

www.pulsar.pl POE044816

GREEN POWER CCTV PoE

4. Service and operation.

4.1. Overload or short-circuit of the power supply output.

The AUX1÷ AUX4 outputs of the PSU are protected against short-circuit and overload by

melting fuse

inserts or PTC polymer fuses. If the PTC polymer fuses are used, disconnect the load from the power supply output
for approximately 1 minute to restore output voltage. (the time needed to cool down the PTC fuse). In case of
melting fuse activation, it should be replaced with a fuse of the same type and of the same rated current.

4.2. Maintenance.

All maintenance procedures can be performed after disconnecting the power supply from the power

network. The PSU does not require any specific maintenance; however, its interior should be cleaned with
compressed air if used in dusty conditions. In case of fuse replacement, use only compatible replacement parts.

WEEE LABEL

Waste electrical and electronic equipment must not be disposed of with normal household

waste. According to the European Union WEEE Directive, waste electrical and electronic

equipment should be disposed of separately from normal household waste.

GENERAL WARRANTY CONDITIONS

1. Pulsar K. Bogusz Sp.j. (manufacturer) grants a two-year quality warranty for the equipment, starting from the production date.
2.  The warranty includes free-of-charge repair or replacement with an appropriate equivalent (selected by the manufacturer) if the
malfunction is due to the manufacturer. It includes manufacturing or material defects, provided that such defects have been
reported within the warranty period (point.1).
3. The equipment subjected to warranty should be brought to the place of purchase or directly to the main office of the
manufacturer.
4. The warranty applies to complete equipment, accompanied by a properly filled warranty claim with a description of the defect.
5.  Should the claim be accepted, the manufacturer is obliged to provide warranty repairs, at the earliest convenience, however
not later that within 14 days from the delivery to the service centre of the manufacturer.
6.  The repair period mentioned in point 5 may be prolonged, if there are no technical possibilities to carry out the repairs, or if the
equipment has been conditionally accepted, due to the breaking warranty terms by the claimant.
7.  All the services are carried out at the service centre of the manufacturer, exclusively.
8. The warranty does not cover the defects of the equipment, resulting from:
- reasons beyond the manufacturer's control,
- mechanical damage,
- improper storage and transport,
- use that violates the operation manual or equipment’s intended use
- fortuitous events, including lightning discharges, power failures, fire, flood, high temperatures and chemical agents,
- improper installation and configuration (failure to follow instruction).
9. The warranty is void in case of construction changes and repairs carried out by any unauthorized service center or in case of
damage or modifications to warranty stickers and serial numbers.
10. The liability of the manufacturer towards the buyer is limited to the value of the equipment determined according to the
wholesale prices suggested by the manufacturer on the day of purchase.
11.  The manufacturer takes no responsibility for the defects that result from the damaging, malfunctioning or inability to operate
the equipment especially when resulting from failure to comply with the recommendations and requirements contained in the
manual.