Pulsar Edge GS 1x20, Instruction Manual, Page: 4 / 4

Direct your binocular at an object to be viewed and adjust the final
focus by rotating the objective lens focusing ring until the image is
optimal. When screwing the objective lenses into the housing, it
focuses on farther objects, when screwing out - on closer ones.
The Edge 1x20 Goggles are intended for joint use with the head
mount (included in the package of #75095). To do this, affix the
binocular to the head mount by means of the screw of the adapter
(see picture) and adjust the device as described above. Additional
information on the operation of the head mount is enclosed with its
user manual.
When you are finished using your binocular place the caps back onto
the objective lenses and turn off the unit by pushing the “ON” (2)
button, the LED indicator will go out. Put the binocular into the carrying
case.
CAUTION!
Your binocular can be used in extreme cold. However, when the unit is
brought back into a warm environment, you must wait approximately 2-3
hours before using the unit again. Failure to do so may result in damage
as a result of condensation accumulating on the internal circuitry of the
unit.
MAINTENANCE
Clean the lens with professional lens cleaning supplies intended for
use with multicoated optics.
Blow any dust or dirt off the lenses using dry, compressed
air. Clean the unit housing with a soft, clean cloth.
STORAGE
During long-time storage please remove the batteries to prevent possible
leakage. The battery cover must be fully screwed during long-time
storage.
TROUBLESHOOTING
The scope will not turn on.
Check that the batteries are installed properly. Install the batteries according
to the (+) and (-) polarity, ensuring that the markings on the battery and
battery compartment correspond with one another. Check the battery
contacts to ensure they are clean and free of corrosion; if necessary, clean
the contacts with rubbing alcohol. Also check that the cap of the battery
department is fully closed, otherwise the device will not operate. If
necessary, replace the batteries as they may be depleted. Also be sure that
the “ON” bu
tton has been pushed and the green LED is on.
Distinct black dots appear on the screen.
These dots are cosmetic blemishes resulting from tube production
processes and do not interfere with the reliability or performance of the
scope and are not a defect.
The image “snows”.
Image may “snow” in a dark environment during 30
-60 seconds after
the device is activated; this effect disappears soon. Image may slightly
“snow” if the device was previously operated without the lens caps at a
high level of luminan
ce. Image may also “snow” if the device is
operated in complete darkness with the IR illuminator off.
The image is not focused.
Adjust the focus of the eyepieces and the objectives (see
“Use and
Testing”
section). Check that the lenses are not foggy or dusty; if they are,
carefully clean the external surfaces of lenses with a soft cotton fabric.
Replace the batteries if the total battery charge is less than 2.2V.
When the unit is brought into a warm environment from a cold one,
condensation may appear on the internal lenses; you must wait two
hours before using the unit.
Visibility decreases or disappears.
Bright light sources, such as headlights, may cause visibility to
decrease or disappear and the image to flicker. Turn the power off and
turn the binocular away from the light source; visibility will restore itself
immediately.