4
4. Preview - the parameters of currently set program.
The program number and time module parameters can be checked by press ing the OK button for 3
seconds. The "PR" LED will light up and the number of the currently set program will be displayed .
Use the
or buttons. The information about the current time parameters of the program -
according to the diagram in Chapter 3: "Pro
gramming the time module” – will be displayed.
The Preview Mode is disabled once the OK button is pressed again or after 5 seconds of inactivity .
5. Previewing the status.
During normal operation, it is possible to preview the time module operating status . Press the or
button; the following information is displayed as follows :
Countdown timer - hours
The
“h” and “T1” or “T2” LED is ON
Countdown timer - minutes
The “m” and “T1” or “T2” LED is ON
Countdown timer - seconds
The “s” and “T1” or “T2” LED is ON
Preview of the status of R and S inputs
A blinking dot indicates the time measurement
of operating module
