background image

Always switch off the cleaner and remove the plug from the electricity power supply before cleaning 
your appliance, when not in use or attempting any maintenance task. The cleaner must only be 
connected to an AC power supply at the voltage shown on the rating label. This cleaner should only 
be used for its intended purpose as described in this instruction manual.

 Never operate the vacuum 

cleaner without filters and dust bag.

1.

  This appliance is not intended for use by 

persons (including children) with reduced 

physical, sensory or mental capabilities 

or lack of experience and knowledge, 

unless they have been given supervision or 

instruction concerning use of the appliance 

by a person responsible for their safety.

2.

  Children should be supervised to ensure that 

they do not play with the appliance.

3.

  To prevent electrical shock, do not immerse 

the appliance, power cord or power plug into 

water or other liquids.

4.

  To prevent electrical shock, do not use the 

vacuum cleaner outdoors or on  

wet surfaces.

5.

  Always check the power cord before use, the 

power cord and the plug should be in a good 

condition and must not be damaged. If the 

power supply cord is damaged or defective, 

it must be replaced by the manufacturer, its 

service agent or similarly qualified persons in 

order to avoid a hazard.

6.

  Do not unplug by pulling on the power cord. 

To unplug, grasp the plug not the power 

cord. Use only Australian and New Zealand 

electrical safety approved extension cords.

7.

  Do not pull or carry the appliance by the 

power cable, use the power cable as a 

handle or pull the power cable around 

shaft edges or corners. Avoid running the 

appliance over the power cable.

8.

  Ensure the appliance is switched off  

before unplugging.

9.

  Do not handle or operate the appliance 

with wet hands and follow electrical safety 

precautions at all times.

10.

  Extreme caution should be exercised when 

using the appliance on stairs.

11.

  Do not attempt to change the attachments 

while the appliance is plugged in to mains 

power supply. Switch off and remove 

plug from mains power supply. Use only 

manufacturer’s recommended accessories.

12.

  Do not operate the vacuum cleaner too  

close to the heaters, radiators and other  

hot surfaces.

13.

  Do not use the appliance to pick up 

flammable items or combustible liquids (i.e. 

gasoline, hot ashes cigarettes, matches, 

explosive materials or anything burning) or 

use in areas where such substances and 

items may be present.

14.

  Do not use the appliance to pick up toxic 

materials (i.e. chlorine bleach, ammonia).

15.

  Ensure the appliance is disconnected from 

the main power supply before connecting the 

hose to the unit.

16.

  Do not operate or use the appliance without 

dust bag and filters in place.

17.

  Before vacuuming, remove any large or sharp 

objects from the floor or cleaning surface in 

order to prevent damage to the filter.

SAFETY PRECAUTIONS AND WARNING:

IMPORTANT

WHEN USING YOUR VACUUM CLEANER, BASIC PRECAUTIONS SHOULD ALWAYS 
BE OBSERVED, INCLUDING THE FOLLOWING;

2

Summary of Contents for PULL10LD













Reviews: