Recommendations
1) verify that the equipment used to connect our devices to enjoy
all the guarantees required under European law;
2) use the cables, connectors and quality materials for electrical wiring;
3) Products with IP65/68 degree make the wiring / connections with accessories
provide the same degree IP of the selected product (available in the catalog);
4) In the case of installations outside is not recommended to install the power supplies in the
formwork and / or in the junction box without adequate protection
Relamping and maintenance:
-The relamping must be done with maximum attention avoiding to dirty the sealing gasket and its contact surface. It is
therefore necessary before
opening the fixture to carefully wipe the floodlight then unscrew the round frame by the proper key
-
it is essential to do a frequent cleaning of the glass and of the outer surface of the fixture to avoid build up of mud and
dirtiness resulting in dangerous
overheating due to uncorrect light and heat dissipation. Clean carefully the glass screen removing limestone deposits
by means of a scraper.
.The replacement must be done by a qualified electrician.
INSTALLATION:
-SWITCH-OFF THE POWER SUPPLY BEFORE CARRYING OUT ANY MAINTENANCE OPERATION
- 1 Open the luminaire uncsrewing the bottom rings
- 2 Drill plugs holes in correspondance of the feeding point : distance 43mm
- 3 Fix the bottom ring to the floor
- 4 Remove the cable gland terminal from the luminaire bracket and open it to make the correct connection respec-
ting the po -
- 5 Insert the cable gland connector into the luminaire tube
- 6 Remount the luminaire tighten the threaded bracket to the bottom threaded rings
-7 Adjust the head of the lamp as desired and fix it by tightening the screw in the joint using the tool included in the pac-
kage
