-Read the instructions for installation and commissioning.
-Pass the instructions to the customer for safekeeping.
-Do not remove the type plate of the luminaire.
-Please note the national installation and accident prevention regulations during installation.
-The installation must be performed only by a trained electrical specialist.
-Damaged cables may only be changed by trained electrical personnel.
-For improper installation or any subsequent change to the luminaire no liability is accepted.
-The light source of this lamp may be replaced only by the manufacturer or an authorized service technician or a similarly qualified person.
-LED lamps (without IP67 protection) must not be cleaned.
-Clean the luminaire regularly with a smooth damp cloth. Only use solvent-free cleaning agents. Attention: previously cut off the mains supply and allow
system to cool down.
-To protect the surface from dirt and fingerprints, we recommend the use of protective gloves during installation.
-The disposal of the system must be carried out on the disposal of electronic products in accordance with the EU Directive WEEE (Waste Electronical and
Electronic Equipment).
-In order to answer technical queries, please contact our project management respectively our worldwide branches and distributors
THE WARRANTY IS FALLING IN THE FOLLOWING CASES:
1) Malfunctions due to improper use of the product, modifications, repairs
inadequate, negligence on the part of the installer / electrician, failure to
assembly instructions and / or data plate;
2) Installations in plants not comply with the general safety;
3) Damage caused by natural causes such as lightning, fire or flooding;
4) Damage caused by wiring / connections with IP degree lower than the selected product.
5) Damage occurring during shipment of the product. In these cases the damage
will be to charge and notify the carrier;
6) The warranty covers only the integrity of the product and NOT any costs of removal
of the same;
INSTALLATION
-THE MAINTENANCE MUST BE MADE BY A QUALIFICATE ELECTRICIAN
-SWITCH-OFF THE POWER SUPPLY BEFORE CARRYING OUT ANY MAINTENANCE OPERATIONS
The luminaire is supplied by us with LED illuminator already installed with built in SELV power supply.
The cable and the fixture must not be tampered with for any reason.
-it is essential to do a frequent cleaning of the glass and of the outer surface of the fixture to avoid build up of mud and dirtiness resul-
ting in dangerous overheating due to uncorrect light and heat dissipation. Clean carefully the glass screen removing limestone depo-
sits by means of a scraper.
1– remove the head of lamp by pushing and rotating it
2– remove the fixing nut by unscrewing it
