Technical Support Available Mon – Fri: 10:00 A.M – 5:00 P.M (Central Time)
Phone: (512) 490-6494 | Email: [email protected] | Website: www.ptpturboblankets.com
Installing your Subaru STI/WRX blanket with Stainless-Steel Wire
**Note: Be sure to allow yourself plenty of excess wire. You can always cut any excess
wire once secured to the turbo blanket.
5.
Locate the stainless-steel wire included in your package. Carefully unwind the
wire to attach the opposing button rivets on the opposite end of the turbo blanket.
As mentioned previously, be sure to allow yourself plenty of wire.
6.
Begin by looping the wire to one of
the button rivets on the non-
contoured (narrow) end of the
blanket several times. This will
anchor the wire allowing you to
make a figure eight pattern around
both button rivets, properly
securing the wire on both ends.
7.
After you have successfully
installed the wire begin fitting the blanket over the exhaust side of the turbo. Feed
the end of the blanket with the wire (narrow end) down around the backside of
the turbo. Be sure to bend the wire back towards the turbo so that you are able to
pull it completely through, with the needle nose pliers, underneath the turbo.
8.
Once you have hold of the wire you can move the blanket into position by pulling
on the wire while feeding the blanket downward.
